Optional Extras

Lower door travks
Going in and out is a lot easier with METAL SHED Co. exclusive entry/exit ramp and it protects the lower door tracks too.

The Process

LASTING GOOD LOOKS
Metal Shed Co. has them with pre-finished steel, zinc coating and colourful baked on finish.

Hilti Hammerscrew
HILTI HAMMERSCREW (for concrete or flagstone bases)-OPTIONAL
A ready to use, quick set impact fastener with high expansion. Fits through pre-drilled holes in the shed's base rail. Masonry bit(15/64") supplied with the Hammerscrews. Simply fix by hammering on the drive screw. Can be removed with a cross recess screwdriver.

translucent panel
One translucent roof panel is included with each APEX
roof shed. Can be positioned on either side of the roof.
Additional panels available at extra cost. NOTE:
translucent roof panels are NOT included with pent
roof sheds, storage boxes nor 'VS'
or GLENWOOD buildings.

SHELF UNIT
Sturdy shelf unit helps organise your storage with
3 Large shelves. Holds up to 85lbs.
(even weight distribution).
Each shelf approx. 11 3/4" x 29 3/4"

2002 Copyright © 2000 WillDesign. All rights reserved.

Independently tested, triple roof beams are
standard to all 8' and 10' fronted buildings.
They give our buildings remarkable strength-
even for heavy snow loads. Our twin, inside
running sliding doors glide open and close on
our exclusive pendulum glide system. No roller
system can match it for reliability and ease of
operation. Specially designed inside tracks.
They won't jump or jamb-in any season

STORM KIT- Optional Comprises exact number
of 31/4" wide vertical, steel wall supports to allow for
each wall panel joint to be over lapped internally from
base rail to eaves. Only available for Standard & Extra
High Gable Sheds with 65" olive walls and both 62"
brown walled pent roof sheds P64 & P84.

A 4' x 2' piece of pegboard hangs an amazing amount
of tools. Hooks for hanging the tools and pegboard
(not supplied) to the rear or any of the two side
walls - either before roof installation (as shown here) or
afterwards. The self tapping screws supplied with the
building are long enough to sandwich
wall panel/pegboard/toprails.

These heavy-duty, hot dipped galvanised steel
frame kits are the perfect base for our apex roof
steel sheds. Easy to assemble before you
construct the shed. No need for a traditional
concrete or slab base - just perfectly level ground
After the shed is fully erected and secured to the
foundation kit, flood out interior with concrete for a
smooth floor or cover with timber or moisture
resistant chipboard. A strong plastic sheet should
be placed BELOW the entire area covered by
the foundation kit to prevent rising damp.

TOOL HANGING RACK
includes twin 25 1/2" steel channels, five snap
in tool holders and an exclusive small tool
holder. Tool holders glide on track for random spacing.